• Hold both hands on router handles always, until a motor has stopped. Do not set the router down until exposed router bit has stopped turning.
• Do not overreach. Keep proper footing and balance.
• When inside routing, start the motor with the bit above the stock. When the router reaches full power, lower bit to required depth.
• When routing outside edges, guide the router counter clockwise around the work.
• When routing bevels, moldings and other edge work, make sure the router bit is in contact with the stock to the left of a starting point and is pointed in the correct cutting direction.

• Feed the router bit into the material at a firm, controlled speed.
• With softwood, you can sometimes move the router as fast as it can go.
• With hardwood, knotty and twisted wood, or with larger bits, cutting may be very slow.
• The sound of the motor can indicate safe cutting speeds. When the router is fed into the material too slowly, the motor makes a high-pitched whine. When the router is pushed too hard, the motor makes a low growling noise.
• When the type of wood or size of the bit requires going slow, make two or more passes to prevent the router from burning out or kicking back.
• To decide the depth of cut and how many passes to make, test the router on scrap lumber similar to the work.

If a router is connected to a router table, refer to Woodworking Machines - Shapers for more guidance.

Refer to Powered Hand Tools - Basic Safety for Electric Tools for general electrical safety tips.