A wood turning lathe can be dangerous if not used properly.

• Read the owner's manual carefully.
• Make sure you understand instructions before attempting to use any tool or machine. Only experienced and trained lathe operators should be allowed to operate lathes.
• Learn the applications and limitations before use.
• Refer to Woodworking Machines - General Safety Tips for general safety precautions.

• Wear safety goggles or face shield to protect yourself from flying chips.
• Wear hearing protection that is suitable for the level and frequency of the noise you are exposed to in the woodworking area.
• Wear a dusk mask when dust is generated (e.g., during sanding operations).
• Work in well-lighted area.
• Before the lathe is turned on, ensure that all clamps and fittings are secure and that the work piece is free to turn.
• Use stock free of defects.
• Hold tools firmly with both hands and against the tool rest.
• Hold the stock securely on the faceplate or between the centres.
• Use only furnished or approved tools.
• Use sharp, well-maintained chisels and gouges.
• Select a speed that is appropriate for the job. Operate the lathe at a low speed and use a moderate cut depth to prevent splinters from flying out during roughing operations. The actual speed of the lathe depends on type of wood, a diameter of stock, nature of work being done and type of tool used.
• Adjust tool rests so that they are parallel and as close as possible to the stock. They should also be set high enough so that tools will cut into the wood slightly above the centre of the work being turned.
• Remove the tool rest when sanding or polishing.

• Do not wear gloves, loose clothing, rings or jewelry around the neck that can hang outside one's clothing. Clothing should be comfortable but not so loose that it can catch on the machine or get entangled with any rotating parts or the wood being turned; shirts should be tucked in and long hair tied back.
• Do not leave a running lathe unattended - leave only after the lathe has been turned off and it has come to a complete stop.
• Do not use makeshift tools.
• Do not use stock containing checks, splits, cracks, or knots.