A radial arm saw can be dangerous if not used properly.

• Read the owner's manual carefully.
• Make sure you understand instructions before attempting to use any tool or machine.
• Learn the applications and limitations before use.
• Refer to Woodworking Machines - General Safety Tips for general safety precautions.

• Wear safety glasses or a face shield.
• Wear hearing protection that is suitable for the level and frequency of the noise you are exposed to in the woodworking area.
• Feed stock against the direction of the blade (the blade should move downward when viewed by the operator).
• Only use saw blades rated at or above the speed of the saw arbour. (An arbour is the attachment from motor to blade)
• Use only the accessories designed for that specific saw and application.
• Ensure the guard consists of two parts:

1. Upper hood type that covers arbour
2. Lower guard that rides on the stock, adjusting automatically to the thickness being cut.

• Stand on the handle side when cross cutting. Pull the cutting head with the hand nearest the handle and maneuver the stock with the other hand.
• Make sure the hand holding the stock is never in line with the blade.
• Return the cutting head completely to the back of the saw table after each cut. The saw should be designed so that the blade will not move forward under its own weight or if the machine is vibrating.
• When ripping, make sure that the overall length of the saw table (both infeed and outfeed) is twice the length of the longest pieces of lumber.
• When ripping, make sure that the stock is fed against the direction of the blade (from the side where the saw blade rotates upward toward the operator). The blade should extend slightly into the table. The motor head must be locked at the correct height and angle.

• Do not use radial arm saws for ripping unless the spreader (riving knife) and anti-kickback devices are provided and properly adjusted.
• Do not take your hand away from the operating handle unless the cutting head is behind the fence.
• Do not remove the stock from a saw table until the blade has been returned to its "resting" position at the back of the saw table. Use a stick or brush to remove scrap from the saw table.
• Do not cut "free hand". Use the back guide or fence, or other device to keep the workpiece from moving.
• Do not use cracked or dull blades.
• Do not leave a running saw unattended - leave only after the saw has been turned off and it has come to a complete stop.